Renesas RH850/U2A 292pin - Page 5

7.4 Device Ports Connectors CN13 to CN16 ............................................................................................ 36
7.4.1 Device Ports Connector CN13 ..................................................................................................... 37
7.4.2 Device Ports Connector CN14 ..................................................................................................... 38
7.4.3 Device Ports Connector CN15 ..................................................................................................... 39
7.4.4 Device Ports Connector CN16 ..................................................................................................... 40
7.5 Pull-Up/Pull-Down Pin Header CN12 .................................................................................................. 40
7.6 Ethernet Connector CN6 and CN17 .................................................................................................... 41
7.7 GPIO/LED Connector CN20 ................................................................................................................ 41
8. Jumper Configuration Examples ............................................................................... 42
8.1 Stand-Alone Operation with Power Supply by Debugger ................................................................... 42
8.2 Configuration Examples ...................................................................................................................... 42
8.2.1 General Settings .......................................................................................................................... 42
8.2.2 Jumper Indicators ......................................................................................................................... 42
8.2.3 Stand-Alone Operation with Single External Power Supply: Minimum Configuration ................. 43
8.2.4 Stand-Alone Operation with All External Power Supplies: Maximum Configuration ................... 44
8.2.5 Operation on the Main Board: No External Supply ...................................................................... 45
9. Precautions ............................................................................................................... 46
9.1 Power-Off Sequence ........................................................................................................................... 46
9.2 CAN0RX is Shared with FLASH Programmer Signal FLMD1 ............................................................ 46
9.3 DeepSTOP Mode when using SVR .................................................................................................... 46
10. Mechanical Dimensions............................................................................................. 47
11. Schematics ................................................................................................................ 48
11.1 Page 1 ................................................................................................................................................. 49
11.2 Page 2 ................................................................................................................................................. 50
11.3 Page 3 ................................................................................................................................................. 51
11.4 Page 4 ................................................................................................................................................. 52
11.5 Page 5 ................................................................................................................................................. 53
11.6 Page 6 ................................................................................................................................................. 54