Renishaw Primo - Table of Contents

i
Contents
Before you begin .............................................................1.1
Disclaimer
.................................................................1.1
Trade marks
................................................................1.1
Warranty
..................................................................1.1
Changes to equipment
.......................................................1.1
CNC machines
.............................................................1.1
Care of the Primo equipment
..................................................1.1
Patents
...................................................................1.2
EC declaration of conformity
...................................................1.3
WEEE directive
.............................................................1.3
FCC Information to user (USA only)
.............................................1.3
Radio approval
.............................................................1.4
Radio equipment – Canadian warning statements
...............................1.4
Radio regulations
.........................................................1.4
Radio approvals
..........................................................1.4
Safety
....................................................................1.6
Information to the user
.....................................................1.6
Information to the machine supplier/installer
....................................1.6
Information to the equipment installer
.........................................1.7
Equipment operation
......................................................1.7
Renishaw GoProbe cycles
....................................................1.8
GoProbe training kit
.......................................................1.8
Primo™ Radio Part Setter and Primo™ Radio 3D Tool Setter basics ..........2.1
Introduction
................................................................2.1
Getting started
...........................................................2.1
Credit
..................................................................2.1
Modes of operation
.......................................................2.1
Configurable settings
......................................................... 2.2
Tool setter switch
-on/switch-off. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.2
Enhanced trigger filter
.....................................................2.2