Renishaw Primo - Page 5

iii
Contents
Preparing the tool setter for use ................................................5.7
Fitting the stylus, break stem and captive link
...................................5.7
Installing the battery
.......................................................5.8
Mounting the tool setter on a machine table
....................................5.9
Tool setter stylus level setting
............................................... 5.10
Preparing the interface for use
................................................5.12
Mounting bracket (optional)
................................................5.12
Interface wiring diagram
...................................................5.13
Interface cable
..........................................................5.14
Interface screw torque values. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.15
Calibrating the Primo equipment
...............................................5.16
Why calibrate?
..........................................................5.16
Calibrating the part setter and tool setter together
............................... 5.16
GoProbe training part calibration
............................................5.16
Calibrating the part setter only
..............................................5.17
Calibrating the probe length
................................................5.17
Part setter and tool setter LED guide
...........................................5.18
Start-up ...............................................................5.18
Acquisition mode
........................................................5.18
Errors
.................................................................5.19
Interface LED signals
.......................................................5.20
Acquisition mode
........................................................5.21
Operational mode
........................................................ 5.22
Error states
............................................................. 5.23
Interface digital display codes
..............................................5.24
Acquisition method
.........................................................5.25
Part setter
.............................................................. 5.25
Tool setter
.............................................................. 5.27
Installing the credit token cassette
.............................................5.29
Changing the credit token
....................................................5.30
Credit transfer
.............................................................5.31
Maintenance .................................................................6.1
Maintenance
...............................................................6.1
Cleaning the equipment
......................................................6.1
Changing the battery
.........................................................6.2
Part setter
............................................................... 6.2
Tool setter
............................................................... 6.3
Permitted battery types
....................................................6.4
Interface cover
..............................................................6.5
Removing the interface cover
................................................ 6.5