Renkforce RF-4818888 - V-5-6-1 Manage Settings; V-5-6-2 Upgrade Firmware; V-5-6-3 Reboot; V-5-6-4 System Log

32
V-5-6-1 Manage Settings
Backup current settings, restore to a previous setting or restore the unit to the factory default settings
in this section.
Backup Settings
Click “Save” to save the current settings on your computer as config.bin file.
Restore Settings
Click “Browse” to find a previously saved config.bin file and then click “Upload”
to replace your current settings.
Restore to Factory
Default
Click “Reset” to restore settings to the factory default. A pop-up window will
appear and ask you to confirm and enter your log in details. Enter your
username and password and click “Ok”. See below for more information.
V-5-6-2 Upgrade Firmware
Use this section to upgrade the firmware of the unit.
Do not switch off or disconnect the device during a firmware upgrade, as this could
damage the device.
Browse
Open a new window to locate and select the firmware file in your computer.
After firmware upgrade, the system will restart.
V-5-6-3 Reboot
In the event that the router malfunctions or is not responding, then it is recommended that you restart
the device.
Rebooting the unit will not affect the current configuration / settings of the device.
Apply
Click “Apply” to reboot the device. A status bar will indicate the progress of
the reboot and you will see a confirmation screen when the reboot is
complete.
V-5-6-4 System Log
Export the system log to a separate file in this section.
Export system log
Click to open a new window and select a location to save the log file.
VI Appendix
VI-1 Connecting to a Wi-Fi network