Renogy 2000W User Manual

34
99 AC output Voltage
Users can select to have the PCL inverter-charger sound an alarm at a programmable battery
voltage. This will need to be a higher value than Program 29 Low DC Cut-off Voltage as it will
warn users that the battery is discharging before ultimately disconnecting.
Allows users to customize AC output voltages for devices that might need to meet a very
specific AC powering criteria.
98 Low Battery Voltage Alarm
98
99 AC output voltage
Low voltage battery alarm
The default is 10.5V. The setting range is 10.5V-12.5V
with increments of 0.1V. This setting will be at least
0.5V greater than setting #29
V
BATT
The default is 120V, can be set between 100V-120V
with increments of 5V
V
OUTPUT

Renogy 2000W Specifications

General

Continuous Power	2000W
Surge Power	4000W
Input Voltage	12V DC
Output Voltage	120V AC
Output Waveform	Pure Sine Wave
Output Frequency	60Hz
THD	<3%
Operating Temperature Range	-4°F to 104°F (-20°C to 40°C)
Protection	Overload, Over Temperature, Short Circuit
Efficiency	90%
USB Port	5V/2.1A
Under Voltage Protection	10V DC