HYD 3K~6K-EPUser manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd。
- 28 -
Step 2
Remove the insulation layer with an appropriate length from the
positive and negative power cables by using a wire stripper as show in Fig.
Step 3Insert the stripped positive and negative power cables
and negative metal terminals respectively and crimp them using a clamping tool.
Ensure that the cables are crimped until they cannot be pulled out by force less than
400 N, as shown in Fig.②③.
Step 4 Insert crimped power cables into corr
esponding housings until you
hear a "click" sound. The power cables snap into place.
Step 5
Reinstall cable glands on positive and negative connectors and rotate
them against the insulation covers.
Step 6
Insert the positive and negative connectors into
terminals of the inverter until you hear a "click" sound, as shown in Fig.
To remove the positive and negative connectors from the inverter, insert a
removal wrench into the bayonet and press the wrench with an appropriate strength,
as shown in Fig.⑦ .
Before removing the positive and negative connectors, ensure that
the DC SWITCH is OFF.
Fig.4-2 Connect PV
Remove the insulation layer with an appropriate length from the
positive and negative power cables by using a wire stripper as show in Fig.
①.
into the positive
and negative metal terminals respectively and crimp them using a clamping tool.
Ensure that the cables are crimped until they cannot be pulled out by force less than
esponding housings until you
Reinstall cable glands on positive and negative connectors and rotate
Insert the positive and negative connectors into
correspondingPV
terminals of the inverter until you hear a "click" sound, as shown in Fig.
⑥.
To remove the positive and negative connectors from the inverter, insert a
removal wrench into the bayonet and press the wrench with an appropriate strength,
Before removing the positive and negative connectors, ensure that
To Next Page
