Rentech HYD 3000-EP - First Time Setup (IMPORTANT!)

HYD 3K~6K-EPUser manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd。
- 51 -
8. For lithium
battery, please ensure that the communication cable has been
correctly connected.
6.2. First Time Setup (IMPORTANT!)
IMPORTANT: Pleasefollowthefollowing procedure to switch
ON
1. Make sure there’s no power generation in inverter’s phase.
2. Turn ON DC switch.
3.
Switch ON the battery. Turn ON DC isolator between battery & inverter
4. Turn ON AC circuit break
er between the inverter GRID port & GRID.
5.
Turn ON AC circuit breaker between the inverter LOAD port & critical load.
6. Inverter should start to operate now.
You need to set the following parameters before inverter
start
Table 6- 1 Set the parameters
Parameter Note
battery, please ensure that the communication cable has been
ON
inverter.
Switch ON the battery. Turn ON DC isolator between battery & inverter
.
er between the inverter GRID port & GRID.
Turn ON AC circuit breaker between the inverter LOAD port & critical load.
start
s to operate.