!
Quick start
Before proceeding with the installation, verify that the
equipment
works on the ground. Power up both units and put
them between
your computer and network access, you should
have full communication within a few minutes of powering up
the units. (If the
units have no internal antenna make sure you
place the antenna
connectors directly opposite each other.)
Both the units are pre-configured in Master mode with the same
IP address, user name and password:
Log in to the units one by one and configure them in Master and
Client mode so they connect to each other.
Installing the link
•
Mount the first unit and point it towards the site of the
second
unit. Power it up and make sure the Power LED is lit
and the
status LED blinks slowly.
•
Mount the second unit. Power it up and adjust it for best signal
using the status LED see section 1.9 for details .
To Next Page
Loading...