REPEATIT Trinity-323 - Configuring Using the Trinity-300 Series Web Interface

!
!
Factory defaults
Static bare basic configuration.
Note The factory default IP address is 10.0.0.1, the default
username is “admin” and default password is “public”.
2.2 Configuring using the Trinity-300 series
web interface
Both units in your Trinity-300 series link can be fully configured
using the built-in web interface. The following section will guide
you through how to use the interface to modify the link
configuration, please refer to section 2.3 for details on the
available configuration parameters.
Figure 2 – Configuration view.
All configuration options in the Trinity-300 series can be found
under the tab marked “Configuration” in the web interface. This
tab is shown below.