REPLIGEN XCell ATF Series User Manual

XCell
TM
ATF System with C410:V4B Controller User Guide
115
Description
Name
Calibration - AIW04 - Point 1 - Engineering Value
P2_P1_EU
Calibration - AIW04 - Point 2 - Engineering Value
P2_P2_EU
Calibration - AIW06 - Point 1 - Engineering Value
PRV1_P1_EU
Calibration - AIW06 - Point 2 - Engineering Value
PRV1_P2_EU
Calibration - AIW08 - Point 1 - Engineering Value
PRV2_P1_EU
Calibration - AIW08 - Point 2 - Engineering Value
PRV2_P2_EU
Calibration - AIW12 - Point 1 - Engineering Value
P3_P1_EU
Calibration - AIW12 - Point 2 - Engineering Value
P3_P2_EU
Calibration - AIW14 - Point 1 - Engineering Value
P4_P1_EU
Calibration - AIW14 - Point 2 - Engineering Value
P4_P2_EU
Calibration - AIW16 - Point 1 - Engineering Value
P5_P1_EU
Calibration - AIW16 - Point 2 - Engineering Value
P5_P2_EU
Calibration - AIW18 - Point 1 - Engineering Value
W1_P1_EU
Calibration - AIW18 - Point 2 - Engineering Value
W1_P2_EU
The audit trail file is recorded on the SD card in the form of a .csv file. This file can be viewed in Siemens
Audit Viewer and includes a validity check to show in Audit Viewer that the file has not been opened.
Opening this file in Excel will null the validity check. For each change entered by a user via the HMI, the
audit trail will record:
• Parameter changed
• Sequential number of the change
• Time of the change
• User responsible for the change
• Original value of the parameter
• New value of the parameter
This information is shown in Audit Viewer in the screenshot below. The data validity indicator can be
seen on the left panel of the Audit Viewer.

REPLIGEN XCell ATF Series Specifications

General

Brand	REPLIGEN
Model	XCell ATF Series
Category	Laboratory Equipment
Language	English