Need help?Do you have a question about the REPLIGEN XCell ATF10 and is the answer not in the manual?
General| Brand | REPLIGEN |
|---|---|
| Model | XCell ATF10 |
| Category | Laboratory Equipment |
| Language | English |
Details the operational cycle of the XCell™ ATF system pump.
Outlines the control capabilities and goals of the XCell™ ATF system.
Details the stainless steel filtration assembly components and connections.
Lists and describes the components within the Pneumatics Box (P-Box).
Details the components housed within the Electrical Box (E-Box).
Describes the components located in the Power Box for power separation.
Explains the primary pneumatic connections and services for the system.
Details the primary electrical connections and services required for operation.
Provides a general overview of the process and control mechanisms.
Explains the algorithms used by the controller for process management.
Describes the user interface and various screens of the controller.
Guides users through the initial setup and startup procedures for the system.
Steps for preparing the filtration assembly before autoclaving.
Details the recommended autoclave cycle for sterilization.
Describes the procedure for making a hard connection to the bioreactor, including SIP.
Recommendations for diaphragm usage, orientation, and lifespan.
To Next Page
