REPLIGEN XCell ATF10 User Manual

XCell
TM
ATF System with C410:V4B Controller User Guide
45
The Administration screen will display parameters in the following tables:
Field
Description
Software Version
Both PLC “4.36” (as shown) and HMI “4.36” (as shown) version numbers
are displayed.
ATF Number
Numerical entry allowing end users to identify ATF controller.
No of Pump
Cycles
Total number of pump cycles of all batches since reset
Profibus Node
Address
Defaulted to 2. This entry field allows for selecting alternate node
addresses.
Pressure
Engineering Units
Either PSI (as shown) or Bar
Display
Date/Time
Either Display (as shown) or Hide. Selecting Hide removes the Date/Time
display from all screens. This was installed in the event that the system
time had lost time synchronization with a central manufacturing system,
but customer request. This value is retained during a power loss of the
controller, making this selection permanent.
CPU
Either RUN (as shown) or Stop
F.2
BASIC

REPLIGEN XCell ATF10 Specifications

General

Brand	REPLIGEN
Model	XCell ATF10
Category	Laboratory Equipment
Language	English