ResMed stellar series User Manual

9Working with other optional accessories
English
To add supplemental oxygen
1 Unlock the low flow oxygen inlet on the back of the device by pushing up on the locking
clip.
2 Insert one end of the oxygen supply tubing into the oxygen connector port. The tubing
automatically locks into place.
3 Attach the other end of the oxygen supply tubing to the oxygen supply.
4 Start ventilation.
5 Turn on the oxygen source and adjust to the desired flow rate.
To remove supplemental oxygen
Before you remove supplemental oxygen from the device, ensure the oxygen supply has
been turned off.
1 Unlock the low flow oxygen inlet on the back of the device by pushing up on the locking
clip.
2 Remove the oxygen supply tubing from the oxygen connector port.
1
2
1
2

ResMed stellar series Specifications

General

Data Storage	SD card
Device Type	Ventilator
Modes of Ventilation	CPAP, S, S/T, T
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	5°C to 40°C
Operating Humidity	10% to 95% (non-condensing)
Operating Altitude	Up to 2500 meters
Sound Level	30 dBA
Humidification	Integrated heated humidifier
Connectivity	Wi-Fi