Your Programme Environments
Programme Description of when to use
Stand-by Function
To put the instrument into stand-by mode, hold down the
pro gramme selector for 5 seconds. You will hear a series of
beeps, and the device is now in stand-by mode.
Before return ing to functional mode, you will need to wait
approximately 5 seconds. After waiting, press the pro-
gramme selector once. Please note that the instrument is
using a small amount of power when in stand-by mode.
On/Off Function
Your ReSound hearing instrument is
equipped with an on/off switch
integrated into the battery com-
partment. When the battery
compartment is fully closed,
the instrument is turned on
in its functional mode and pro-
gramme 1 will be activated. To turn
the instrument off, open the battery
compartment with your fingernail. Whenever you are
not wearing the instrument, remember to turn it off to reduce
battery consumption.
Programme Selector
Your hearing care professional has most likely programmed
multiple programmes into your instrument. You can select
programmes simply by depressing the programme selector
once. You will then hear one or more “beeps”, indicating
which programme you have selected. Your hearing instru-
ment will switch programmes as follows:
Example with 4 programmes: 1 → 2, 2 → 3, 3 → 4, 4 → 1
Example with 3 programmes: 1 → 2, 2 → 3, 3 → 1
Example with 2 programmes: 1 → 2, 2 → 1
You can always return to programme 1 by turning your in-
strument off and then on again or by placing it in stand-by
mode and then returning to its normal function mode.
→
To Next Page
Loading...
Need help?
General
