BATTERY POWER SOLUTIONS
Page 1 of 2 December 2017
REQUIRED COMPONENTS
Freedom
TM
CPAP Battery Kit
150W Sine Wave Power Inverter (inverter)
CONNECTION INSTRUCTIONS
Plug the DC input cord into the DC OUT jack of the battery.
Plug the inverter into the DC input cord.
Plug the AC power cord of the PAP device into the inverter.
Turn the PAP device on and it should begin functioning.
The digital display screen will show the charge level of the battery. You may press the charge level indicator
button to illuminate this screen. It will stay illuminated for a few seconds at a time.
When not in use disconnect all devices from the battery thus allowing the battery to completely shut down.
The inverter can also be used to charge the battery in a vehicle (vehicle does not need to be running) and to power/charge
other small electronic devices with the
battery. The inverter is not proprietary to the Freedom
TM
CPAP Battery and can be
used with other external batteries.
OPTIONAL FREEDOM
TM
CPAP BATTERY CHARGING ACCESSORIES
Auto Charge DC Cable {BPS DC.CABLE}: Used to charge the battery in a vehicle (vehicle must be running).
SunPower 40W Solar Panel {BPS SP40}: Used to charge the battery using the power of the sun.
PLUG IN PAP DEVICE
AC POWER SUPPLY
DC INPUT CORD
150W SINE WAVE
POWER INVERTER
DC OUT JACK
R
espironics DreamStation Go: Single Battery Connection
To Next Page
Need help?
General
