Millennium M10
Operating Instructions
Warning: Do not use extension cords or electrical adapters
1. Select a location that allows the oxygen concentrator to
draw in room air without being restricted. Make sure that
the oxygen concentrator is at least ¼ ft. away from the
walls, furniture, and especially curtains that could impede
adequate airflow to the device. Keep away from heat.
2. Plug the power cord into an electrical outlet.
3. Connect the oxygen tubing to the oxygen outlet port.
i. You may a l s o a t t a c h a humi d i f i c a t i o n c u p to t h e
oxygen outlet port. Make sure the cup is filled
to recommended amount and attach cannula to
hummidication cup.
4. Press the power switch to the On ( I ) position. Initially all
the indicator lights will turn on and the audible alarm will
sound for a few seconds. After that time, only the green
indicator light should remain lit.
5. After turning on the Oxygen Concentrator, you can begin
breathing from the device immediately; however, allow at
least 10 minutes for oxygen delivery to reach defined
specifications.
To Next Page
General
