Respironics DreamStation Series User Manual

Respironics DreamStation Series: Single Battery Connection
BATTERY POWER SOLUTIONS
Page 1 of 2 June 2016

DC OUT JACK

12V POWER
ADAPTER
PAP DC
INPUT PORT

The DC input port on Respironics DreamStation series devices require a proprietary signal in order to recognize a
valid power source; therefore, the use of a 12V power adapter is required in conjunction with the Freedom
TM
CPAP
Battery. Our 12V power adapter was designed specifically for use with Respironics DreamStation series devices and
the Freedom
TM
CPAP Battery.
REQUIRED COMPONENTS
 Freedom
TM
CPAP Battery Kit
 DreamStation 12V Power Adapter
CONNECTION INSTRUCTIONS
 Plug the 12V power adapter into the DC OUT jack of the battery.
 Plug the 12V power adapter into the DC input port of the PAP device.
 Turn the PAP device on and it should begin functioning.
 The digital display screen will show the charge level of the battery. You may press the charge level indicator
button to illuminate this screen. It will stay illuminated for a few seconds at a time.
 When not in use disconnect all devices from the battery thus allowing the battery to completely shut down.
OPTIONAL FREEDOM
TM
CPAP BATTERY CHARGING ACCESSORIES


 Auto Charge DC Cable {BPS DC.CABLE}: Used to charge the battery in a vehicle (vehicle must be running).


 150W Sine Wave Power Inverter {BPS 150 INVERTER}: Used to charge the battery in a vehicle (vehicle does not need to
be running) and allows the battery to power/charge other small electronic devices.


 SunPower 40W Solar Panel {BPS SP40}: Used to charge the battery using the power of the sun.

Respironics DreamStation Series Specifications

General

Manufacturer	Philips Respironics
Pressure Range	4-20 cm H2O
Sound Level	26 dBA
Humidification	Integrated Heated Humidifier
Data Storage	SD Card
Altitude Compensation	Automatic
Compliance Data	Yes
Display	Color LCD
Operating Noise Level	26 dBA
Device Type	CPAP, BiPAP
Ramp Time	0 to 45 min (5-min increments)
Power Supply	100 - 240 VAC, 50/60 Hz
Therapy Modes	CPAP, Auto CPAP
AC Power	100-240V, 50/60Hz
DC Power	12V

Summary

Respironics DreamStation Single Battery Connection

Required Components for Single Battery

Lists essential components for connecting a single battery to the DreamStation.

Single Battery Connection Instructions

Step-by-step guide for connecting the PAP device to a single battery.

Optional Battery Charging Accessories

Accessories available for charging the CPAP battery using various power sources.

Respironics DreamStation Dual Battery Connection

Required Components for Dual Battery

Lists essential components for connecting two batteries to the DreamStation.

Dual Battery Connection Instructions

Step-by-step guide for connecting the PAP device to two batteries.

Optional Battery Charging Accessories

Accessories available for charging the CPAP battery using various power sources.