Retevis MA1 - Page 22

To store numbers in the number memo, the operation is as follows:
1)Press the [F] key + tuning key to enter the menu.
2)Rotate the tuning knob to select menu No. 301 (DT.MEM).
3)Sho press the tuning knob, and then rotate it to select a memo to store the number.
There are a total of 16 number memories, numbered "d-1" ~ "d-16".
4)Sho press the tuning knob again, and then rotate it to select the rst number.
5)After selecting, press the tuning knob to conrm, and then rotate it again to select the
second number.
6)Repeat the above steps to enter all numbers. If the input is incorrect, press the [DOWN] key
on the microphone to return to the previous character and re-enter.
7)After all numbers are entered, press the tuning knob to store the set numbers in the
machine.
8)If you want to store another set of numbers, rotate the tuning knob to select another
number memo. Then repeat the above steps 1-7.
9)After all the inputs are completed, press the tuning knob to conrm, save and exit.
To send numbers in the number memo, the operation is as follows:
1)Press the [F] key + tuning key to enter the menu, and rotate the tuning knob to select the
number memo where the number to be sent in menu 301 (DT.MEM) is located.
2)Sho press the tuning key to conrm the save and exit.
3)Press and hold the PTT key and press the [CALL] key of the main working machine to
transmit the selected number.
4)Once you press the [CALL] key, you can release the PTT key and the machine will continue
to send numbers until it is nished.
You can select the sending speed of the machine's automatic number sending and the delay
time for sending DTMF numbers after pressing the [CALL] key through menu 302 (DT.SPD)
and menu 303 (DT.PAUS).
2-Tone and 5-Tone signaling operations
Unlike DTMF signaling operations, 2-tone/5-tone signaling can only be sent through the
autodialer, not directly through the microphone. At the same time, the number can only be
stored in the dialing memo through the frequency writing software, and cannot be achieved
through menu operation.
Sending 2-tone/5-tone signaling:
1)Select the memo where the number you want to send is located through Menu 603 (2
TONE) and Menu 604 (5 TONE).
2)Press and hold the PTT button and sholy press the [F] button to send 2-tone signaling;
sholy press the [Tone] button to send 5-tone signaling.
Cross-band repeater function
This mobile radio can be easily set up as a full-featured cross-band repeater station through
the menu. This is ve useful when you are in a remote area or in an emergency and need to
set up a small cross-band relay.
Note:
1．Choose the uplink and downlink frequency carefully to avoid aecting other people's
communications. If you are not sure about the frequency usage in your area, it is best to use
simplex communication on all bands, or consult the local frequency management depament.
2．Remember that the communication trac of your repeater system may far exceed your
expectations, so it is best to reduce the power coverage as much as possible.
18