Transmitting
Select your desired band and frequency/channel.
Press and hold the microphone [PTT] switch and speak into the microphone to transmit.
Please keep the microphone 2.5 ~ 5CM away from your mouth, not too close or too far, and
speak in a normal voice. Speaking too close to the microphone or too loudly may increase
distoion and reduce intelligibility of your signal at the receiving station.
Select the transmit power level
Press the [LOW] key repeatedly to select the transmit power level, there are 3 levels in total.
The transmit power of the stored channel can only be adjusted temporarily. After switching to
another channel and then returning, it will return to the original transmit power level. The
H/M/L icon appears on the display, depending on what output power you have selected.
Menu Settings
1 Press [F], Tuning control to access the Menu.
The Menu name and number appears on the display.
2 Rotate the Tuning control to select your desired Menu.
3 Press the Tuning control to set up the current Menu.
4 Rotate the Tuning control to select your desired value for the selected Menu.
5 Press the Tuning control to set the selected value.
6 Repeat steps 2 to 5 to set up additional Menus.
• Press [F] (ESC) at any time to exit Menu mode.
• Press [TONE] (BACK) at any time to cancel the Menu setup and return to the Menu
selection.
Menu No. Display Description Setting Values
Default
setting
000
001
101
102
108
109
200
202
300
301
Beep sound
Beep volume level
Step frequency
OFF/ON
1-15
Beat shift
Time-out timer
Memo name setup
Memo channel lockout
DTMF transmission hold
DTMF memo
OFF/ON
OFF/0-30（mins）
Maximum 6 characters
OFF/ON
OFF/0-10 s
d1-d16
ON
5
12.5
OFF
10
OFF
2S
BEEP
BP.VOL
STEP
MODLAT
B.SHIFT
TOT
M.NAME
L.OUT
DT.HOLD
DT.MEM
Modulation/demodulation
mode
2.5,5,6.25,7.5,8.33,10,12.5,15,20,25,
30,50，100
FM Wideband NFM Narrowband
AM Modulate
13
To Next Page
Loading...
