29
Tips:
When the selected channel is a blank channel, the channel number font is displayed in blue; if the selected
channel is originally had set the parameters of the channel, the channel number is displayed font is yellow.
MEM-CH
In channel mode or frequency mode, press [MENU] + [2 SQL] [7 VOX], the screen displays:
Press [MENU] to enter, press [UP] / [DOWN] keys to select the desired channel number storage, press the [MENU]
to confirm，press the [EXIT] key to exit.
When the working mode is MR mode. Will copy all parameter expect MR name and scan will in channel.
When the working mode is VFO mode, you can set different offset frequency and frequency direction and other
channel parameter enter storage channel, so you can set the same spectrum frequency or different frequencies
pilot frequency your channel.
Example "RX frequency 450.025MHz, CTCSS 67.0Hz, TX frequency 460.025MHz, stored in the first 10 channels.
1. In the frequency mode, frequency 450.025, press [MENU] + [1 STEP] [5 ROGER] setting RX CTCSS function,
press [UP] / [DOWN] keys to select 67.0Hz, press [MENU] to confirm.
2. Press the [MENU] + [2 SQL] [3 SAVE] to set the offset frequency 10.000MHz, Choose offset frequency direction
is positive +.
3. Press the [MENU] + [2 SQL] [7 VOX] into the storage channel, select the channel no.10, Press [MENU] to
confirm and back to standby.
In the standby, press [MENU] + [2 SQL] [7 VOX] to enter the channel stored, To input channel number of hundred’s
digit, ten’s digit and unit’s digit, press [MENU] to confirm.
30
Tips:
The first channel can’ t be deleted.
When the selected channel is a blank channel, the channel number font is displayed in blue; if the selected
channel is originally had set the parameters of the channel, the channel number is displayed font is yellow.
Tips:
Current working channel or frequency corresponding to the carrier signal is not received, the function is not working.
Reverse the scan direction, press [UP]/[DOWN] keys or rotate the channel knob.
When scan the CTCSS frequency, it will stay in screen, then you can press to save. If scan no we need, can press.
DEL-CH
SCNCD
Channel Delete setting (DEL-CH) ---Menu 28
In the Standby, press [MENU] + [2 SQL] [8 W / N], the screen displays:
Press the [MENU] to enter, press the [UP] / [DOWN] keys to select the channel number to be deleted, Press the
[MENU] to confirm, press [EXIT] back to standby.
SCNCD scan setting ---Menu 29
This function scan all CTCSS frequency, If there is a launch CTCSS frequency to determine the launch party. When
you are with a group of people are using CTCSS frequency does not match, can use this function to determine
CTCSS frequency.
In the standby, press [MENU] + [2 SQL] [9 VOICE] key, the screen displays:
Press the [MENU] to enter the CTCSS scan.
To Next Page
Loading...
