Retigo orange vision - STARTING THE CLEANING PROCESS

34
7.2 STARTING THE CLEANING
1 PRESS
2 CHOOSE CLEANING
3 PRESS
4 CHOOSE PROPER PROGRAM
5 PRESS
It appears PRESS START
5 TO START THE CLEANING PRESS
TO RETURN TO THE MAIN MENU
PRESS
6 COMBI OVEN WILL ASK YOU TO
INSERT ADETERGENT
When Start is pressed, the combi oven automatically checks that the
temperature inside the cooking chamber is not too high. If the temperature
is above 176°F, the automatic process for cooling the cooking chamber will
begin.
If the temperature does not exceed 176°F or cooking chamber cooling has
finished, your appliance will prompt you to add detergent.
When handling the detergent, follow all rules for working
with chemical substances!
ADDING DETERGENT
• Cut open the detergent bag at the place
indicated
• Pour the entire contents of the package
on to the drain lid at the bottom of the
cooking chamber. Most of the powder will
fall through into the drain hole.
• close the combi oven door
The selected program will start automatically, and the screen will keep you
informed about the current status of the program and the cleaning time left.
After the cleaning program ends, a signal sound is made and amessage
appears.
STOPPING THE CLEANING PROGRAM PREMATURELY
You can interrupt the cleaning process during the main step with the STOP
button shown on the screen. If detergent has already been inserted, the
combi oven switches to Rinse with Water mode, which lasts about 17min.
Then the washing process completely stops. If detergent hasn’t been
inserted yet, the cleaning process immediately stops (without going to
Rinse with Water).
• When the cleaning process has finished, check the cooking chamber.
Remove any remaining detergent by thoroughly rinsing with the
hand shower or cleaning with water. If this isn’t done, the stainless-
steel surface of the cooking chamber can distort and discolour
when the appliance is used at high temperatures. The warranty does
not cover damage caused in this way!
• Do not disconnect the electricity to the combi oven during cleaning.
Bits of detergent may remain in the cooking chamber.
• Do not wash the combi oven using equipment that works with high
water pressure.
• If the combi oven won’t be used again after cleaning, we recommend
leaving the door ajar, for example overnight
• Dispose of the detergent package as usual, by putting it in aplace
reserved for plastic bags.
• Never leave used packages lying around freely accessible.
DESCALING OF COOKING CHAMBER
Descaling is recommended when there are visible lime scale deposits in
the cooking chamber (awhite layer of water scale), this depends on water
hardness.
To perform descaling on the RETIGO Vision combi steamers it is necessary
to use aspecial agent called Vision Descaler. The Vision Descaler is applied
in the same way as the Active Cleaner.
The standard package size for the Vision Descaler is a plastic bucket
containing 25 bags weighing 100 grams each.
User’smanual | Orange Vision Combi Ovens I7 MAINTENANCE