RetroSound Model Two - Wiring Safety and Lead Protection

Model Two Owner’s Manual
Copyright 2014 © Retro Manufacturing, LLCPage 8
• Use the designated parts and tools for installaon. Use the supplied or
designated parts and appropriate tools to install the product. The use
of parts other than those supplied or designated may result in internal
damage to the unit. Faulty installaon may lead to an accident, malfuncon
or re.
• Do not use safety-related vehicle components Be careful not to wire or
ax this product to the following parts of the vehicle: fuel tank, brake,
suspension, steering wheel, pedals, airbag, etc.
• In the case of installaon to an airbag-equipped car, conrm warnings
and cauons of the vehicle manufacturer before installaon.
• Check for piping, gasoline tank, electric wiring, and other items before
installing the product. If you need to open a hole in the vehicle chassis to
aach or wire the product, rst check where the wire harness, gasoline
tank, and electric wiring are located. Then open the hole from outside if
possible.
• Never install the product in a locaon where it interferes with your eld
of vision.
• Never splice into the power cord to supply other equipment with power.
• Aer installaon and wiring, you should check the normal operaon of
other electrical equipment. The connuaon of their use in abnormal
condions may cause re, electrical shock or a trac accident.
• Make sure the leads do not interfere with driving or geng in and out of
the vehicle.
• Insulate all exposed wires to prevent short circuing.
• Do not operate the unit for a prolonged period with the engine turned
o. Operang the audio system for a long period of me with the engine
turned o will drain the baery.