RetroSound Model Two - Troubleshooting; Common Issues and Solutions; System Reset Procedure

Model Two Owner’s Manual
Copyright 2014 © Retro Manufacturing, LLC Page 33
Bluetooth Instructions
Bluetooth Hands-Free and A2DP Streaming Operaon
You can make or receive phone calls using a Bluetooth enabled phone connect-
ed to the Model Two, controlling basic funcons via the radio interface. During
a call, the radio music source will be muted and the call broadcast through
your car speaker system. You can also listen to music stored on a A2DP enabled
Bluetooth device.
Pairing a Bluetooth Device
When connecng a Bluetooth device for the rst me, you must rst pair the
device with the unit.
For most devices, pairing only needs to be done once.
Please follow these steps:
1. Make sure the BT (Bluetooth) funcon is turned “ON” in the radio Sub-
Menu. See “Sub-Menu System” on page 25.
2. Change the “BT DISCON” funcon to “BT CONNEC”.
3. Ensure Bluetooth is enabled on the phone to be connected to the unit.
4. Search for a new Bluetooth device from the phone (this may take up to 30
seconds).
5. Select “RETROSOUND” from the Bluetooth device list.
6. Some devices may require you to enter a PIN. If prompted, enter “0000”
for the PIN.
7. “PAIRING OK” will be displayed on the LCD display if pairing is successful.
The paired device will then connect to the Model Two automacally.
On some phones, you may need to select “SET AS AUTHORIZED” or similar to
ensure the Model Two will automacally pair on subsequent usage.
PAIRED NOTIFICATION DISPLAY: When the Bluetooth device is paired with the
Model Two, the Bluetooth icon will appear on the LCD display. This should
occur whenever you use the system while the paired device is in range.