Reverse Tap RD B1 - Foam and Cleaning Modes; Foam Mode; Cleaning Mode

Foam Mode
In this mode, users can create the beer foam and change the amount of it by controlling the
number of foam making action
• Press Up and Down button to select number of foam making from 0 to 5.
(ex. 0 means no foam making action. 1 means one time foam making action)
Cleaning Mode
In this mode, users can clean the dispenser valve and beer tubes by executing cleaning
function. Daily cleaning is recommended
• To execute Cleaning Mode, the below procedure must be done
1) Change the nozzle of the dispenser to the cleaning nozzle
(Cleaning nozzle is included in the dispenser package. If lost, contact the distributor)
2) Connect the tube with the nozzle and place the end of the tube into the drain basket
3) Lock the middle valve of CO2 tank and change the beer KEG to the cleaning KEG
(Cleaning KEG and cleaning chemicals can be purchased from the market)
4) Open the middle valve of CO2 tank and press Start button twice
5) The valve will open and cleaning function will start. (Text on the display will change to
Now Cleaning)
6) After draining all the water from the cleaning KEG, stop the Cleaning Mode
7) To stop cleaning, press Stop button. Then, the valve will close and text of the display
will change back to Cleaning Push Start
• After finishing Cleaning Mode, you can disconnect the cleaning KEG and replace with
the beer KEG
Foam
Number of
foam making : 3
Cleaning
Push Start
Now Cleaning
12