19
b Clean and dry the area where you will place the
body pads.
c Make sure REVITIVE Advanced is switched off. If the
control panel is still illuminated, press the power button
and turn REVITIVE Advanced off.
d Attach the ends of the body pads to the body
pad cord.
Press connectors until no gap is between them.
Leaving a gap may cause discomfort.
e Plug the other end of the body pad cord into the
opening on the side of REVITIVE Advanced.
Plugging in the body cord will automatically turn
the foot pads off and intensity will reset to zero.
f Remove the plastic liner from the body pads, by
peeling it off carefully. Replace the body pads onto
the plastic liner after use.
To Next Page
Loading...
