RANGE 3D Scanner User Manual
COPYRIGHT ©2022 REVOPOINT 3D ALL RIGHTS RESERVED 18
Scanner Calibration
Your RANGE 3D Scanner was calibrated in the factory and only
needs to be recalibrated after a year of use or if the scanned results do
not match the specified accuracy.
Safety Maintenance Instructions
1. Small parts, such as markers and USB adaptors, are dangerous if
swallowed. Keep all components out of reach of children and animals
to avoid serioud injury to them.
2. Store the scanner and all accessories in a cool, dry place away from
direct sunlight.
3. Do not allow the scanner to come into contact with or become
immersed in water or other liquids. If it gets wet, wipe them dry with
a soft, absorbent cloth. Operating a scanner that has fallen in water
may cause permanent component damage.
4. Keep the cameras (the two IR cameras, one RGB camera and a
projector) clean. Use 95% isopropyl alcohol and a soft cloth to clean
them.
5. Handle the scanner with care to avoid hitting the cameras.
6. The operating temperature range of this product is 0°C to 40°C
(32°F to 104°F).
7. Do not take apart the scanner. If there are any problems or
questions, contact the Revopoint customer service team at
customer@revopoint3d.
To Next Page
Loading...
