Revox STUDIOART A100 - Connecting STUDIOART A100 to B100 Bass Module; Without the STUDIOART App Proceed as Follows; Proceed as Follows with the STUDIOART App

A100 Room Speaker
STUDIOART
12
Connecting STUDIOART A100 to B100 Bass Module
When pairing, an A100 is defined first, either directly on the device or via the STUDIOART App, as the main speaker. Then you
initiate the pairing process on the B100 Bass Module itself. After successful pairing, the B100 will be listed as a connected
Speaker in the app and can be further configured there.
Distance: For the pairing process, the A100 and the B100 should be no further than 2 m apart. In normal operation, the
distance between A100 and B100 may be up to 10 m, provided there are no strong sources of interference such as
repeaters, microwave sources, baby monitors, etc. active in the area. From an acoustic point of view, however, the
distance between A100 and B100 should be kept as small as possible.
B100 Bass Module: amplifier unit rear view
Without the STUDIOART app proceed as follows:
1. Switch on the A100 by pressing and holding - Status LED lights up 
2. Switch on B100 on the rear panel using the mains switch - Status LED lights up 
3. Define A100 as chief loudspeaker:
+ hold for more than 8 sec - status LED flashes fast first, then slowly 
4. Defining B100 as connected loudspeaker: hold the pairing button
on the back of the subwoofer for approx. 5 sec-
status LED blinks
5. Wait until both devices have found each other. Then the A100 LED again shows the source with the corresponding LED
color and the status LED on the B100 permanently shows the pink LED - done.
Proceed as follows with the STUDIOART app:
1. Switch on the A100 with a long press - Status LED lights up 
2. Switch on the B100 on the back with the help of the power switch - Status LED lights up 
3. Define A100 as the chief loudspeaker: # Call A100 Setup
# Select pairing menu # Activate with START pairing #
Start connection process with “OK” # Perform step 4 within 60 seconds - Status LED flashes slowly 
4. Defining B100 as connected loudspeakers: Hold the pairing button
on the back of the subwoofer for approx. 5 sec-
Status LED flashes 
5. Wait until both devices have found each other. Then the A100 LED again shows the source with the corresponding LED
colour and the status LEDs on the B100 permanently show the pink LED - done.