Connection panel A100
Mains Supply Jack [15 VDC IN]
The A100 uses a low voltage of 15 V DC for its operation. The A100 is designed for permanent use with a connected external
power supply. The input voltage of this power supply may be between 100 and 240 VAC. Use only the supplied original power
adapter. Other manufacturer’s power supplies can damage the A100. In this case, Revox disclaims any warranty.
LAN connection [LAN]
If it is not possible to operate the A100 in a stable WLAN, the A100 can also be connected to a router or switch with a patch
cable. There are two things to keep in mind:
1. As soon as one A100 is connected to LAN, all other STUDIOART loudspeakers must also be connected to LAN. A mixture of
LAN and WLAN operation is not possible.
Reset button [Micro opening]
If the A100 can no longer be controlled and does not accept commands via the user interface (glass touch panel) or via the
STUDIOART app, a reset can be carried out using a straightened paper clip or similar object. The main processor is rebooted and
a reboot is performed. The A100-specific settings such as Wi-Fi key or the audio configuration are retained.
Analog input [Aux-IN]
External devices can be played back via the A100 via the local analog input. This can e.g. be a CD player, TV or a Smartphone.
For mobile devices with low output levels, there is a special setting in the STUDIOART app. A detailed description can be found
in the chapter STUDIOART App of this manual. The analogue input is equipped with signal recognition, which automatically
turns on the A100 as soon as a music signal is present.
Note:
The automatic switch-on is level dependent, i.e. at very low signal levels, it may happen that the A100 is not turned on or turned
off too early. If necessary, increase the input signal while reducing the volume.
External loudspeaker [ P100]
Connection to the passive loudspeaker P100 from the STUDIOART series.
USB Service Port [USB]
This port is designed for factory-internal control and programming processes only.