A100 Touch user interface
Charging the battery
Please charge the A100 Room Speaker with the enclosed power supply unit. While the battery is charging, the center LED lights
up bright orange. After successful charging this changes to green.
Switching the A100 on
Press and hold the button for approx. 2 seconds until the 5 preset LEDs start to flash simultaneously. After approx. 30
seconds, the A100 is ready for operation and the status LED flashes white if there is no internet connection; otherwise the
status LED lights up steady white.
Switch source
Press and hold the key until the source LED starts to change colour. Two sources are available locally:
green : Local analogue input [3.5 mm jack plug on rear of housing]
blue : Bluetooth connection [BT name: Revox A100]
white [Preset LED]: Stored Internet radio stations. Not used at new delivery.
Info: If no music is played via the sources, the source LED will flash. Presets 1-5 for Internet radio stations can be set up via
the STUDIOART app.
Adjust volume
With the two buttons and you can set the desired volume. During the volume change, the 5 preset LEDs indicate the
approximate volume.
Shut down A100
Press and hold the (Play / Pause) button for approx. 2 seconds until all LEDs have gone out. The A100 is now completely
switched off and can only be switched on again at the A100. The STUDIOART app he is not available in this condition.
Put the A100 into standby
Press the button briefly (Play / Pause). After a break of more than 20 minutes, the A100 automatically goes into standby. In
this operating state, the app can be accessed at any time on the A100.
To Next Page
Loading...
