... continue previous chapter
Note: When the B100 is wirelessly connected with other STUDIOART products, the
controls on the rear of the B100 bass module for “volume”, “crossover frequency” and
“phase” are disabled. The settings are automatically set by the STUDIOART system. The
gain and phase setting should be made at the listening position when the placement of
the speakers is completed. Only then can the acoustics be correctly assessed.
Gain.
With reinforcement, the personal preference for the volume of low frequencies can be
determined. The adjustable range is in the range of - 6 dB to + 6 dB. This setting only
affects the B100, not the A100.
.Phase.
The phase adjustment determines how the individually radiated bass waves between
A100 and B100 behave towards each other. Depending on the location, the two bass
waves at the listening position can add up to a balanced frequency response or even
cancel out. For the phase determination, it is recommended to select a song that
contains low-frequency bass passages in the range of 40 - 150 Hz. Find the phase setting
where the bass sounds most intense. The differences between 0° and 180° are fluid and
may be marginal, depending on the type of music chosen.
To Next Page
Loading...
