Revox Voxnet 219 - Display

Operation Voxnet 219
11
Display
Various operational data can be called
up through the Setup button.
The Voxnet 219 is supplied with the current Voxnet server
firmware over the bootloader.
The Voxnet 219 starts up after the firmware has been 100%
updated. This state is shown briefly in the display.
After start-up, the Voxnet 219 receives its IP address from the
router via DHCP. This can take a few seconds.
When the unit is delivered, the
R
oom is displayed with the
corresponding MAC address from the Voxnet 219. The room
identifier is completed with a (0). After configuration through
the Voxnet Configurator, the display shows the assigned
"Room alias". A level display gives information about the
amplifier / output volume status.
As with the room, the
S
ource is defined as a combination
with the MAC address. The source identifier is competed
with a (0). After configuration through the Voxnet
Configurator, the display shows the assigned "Source alias".
A level display gives information about the input level of the
current source.
Source index:
CO
: coaxial
OP
: optical
AN
: analogue
The
T
rigger ([IN/OUT) is also defined as a combination with
the MAC address. The trigger is completed with an indexing
value. After configuration through the Voxnet Configurator,
the display shows the assigned "Trigger Alias". The status of
the IN and/or OUT trigger is shown in the bottom line of the
display.