Revv Owner’s Manual - 16
FX Loop Connections
The FX loop connections are to be hooked up to external pedals or
effects units. The Send level will supply the signal required & needs to
be set accordingly with the send level control.
1 - 8 ohm cabinet WITHOUT the provided 8 ohm combo speaker: In this
configuration, the provided speaker would be disconnected from the 8
ohm jack & the 8 ohm speaker cabinet would be plugged into that same
jack. The remaining 4 ohm speaker jacks MUST NOT be used. The pro-
vided speaker cannot be used in this configuration & must remain
disconnected.
1 - 4 ohm cabinet: In this configuration, only one 4 ohm speaker cabinet
can be used with this amplifier. The provided 8 ohm combo speaker
MUST NOT be used, the remaining 4 ohm and 8 ohm speaker jacks
must also NOT be used.
2 – 4 ohm cabinets cannot be run in parallel with this amplifier. This will
cause damage.
3.4
To Next Page
Loading...
