Revv Owner’s Manual - 25
MIDI Channel Setting
This amplifier can either automatically or manually change the 16 MIDI
channels you would like it to respond to. The channel change is stored in
memory & only needs to be done when you need the amp to respond on
a certain channel.
1) In order to set the MIDI channel:
With the power off, press & hold the bright switch then turn on the power
switch. The amp will power up & begin to flash 4 LEDs. Once this hap-
pens it is awaiting the channel data to be received from the external
equipment (Automatic) or to be set manually.
2a) To set the channel automatically: (recommended)
With your external equipment ready (pedals, computers, etc.) & set to
the channel you want the amplifier to be controlled from via MIDI, send a
command to the amplifier by pressing a program change button or CC
command on your external equipment. Once the amplifier receives the
data, it will verify the channel it received & save it to memory. Easy!
2b) To set the channel manually:
Once step 1 has been completed above & the channel LEDs are flashing,
press the Channel toggle switch (up). The Channel will flash & the other
LEDs will turn off, this signifies that MIDI channel 1 has been selected.
Simply continue to press the CH 1 toggle switch (up) to get to the chan-
nel you desire. As you press the switch you will notice the other LEDs turn
on as you increase the MIDI channel number. Once you reach the chan-
nel you desire, press the bright switch to save it to memory.
6.2
To Next Page
Loading...
