Revv Owner’s Manual - 7
Channel One (Clean)
Selected by: 1) pushing the designated front panel momentary toggle
switch up (LED turns blue), 2) footswitch button #1 or a footswitch
preset mode setting, 3) MIDI & CC commands.
Passive treble, middle, bass, & level controls with a wide range. Small
turns = large tonal change!
Bright changes top end response for a more sparkly tone. It is normally
best to choose the bright setting you prefer (on or off) & then dial treble
to taste. Also useful when switching between humbuckers & single coils!
Very warm & full-bodied clean channel. Takes pedals very well - or
decrease power to 7 watts for a more broken up sound with the Output
Power Switch. Channel output power is independent so you can use
this to control both tone & volume separately from the gain channel.
2.2
To Next Page
Loading...
