Revv Owner’s Manual - 19
Note: The level controls on each channel will also affect the send level
being sent from the effects loop - when one is set higher than the rest
you will find your signal changes when using that channel. Be sure to test
each channel & the send level coming from the effects loop. For this
reason it is normally preferable to set the level of your channels first then
adjust your effects loop send level.
FX Loop Hook up
First, you need to hook up your effects units to the amplifier. The send
jack will need to be connected to the input of the first (or only) effects unit
in your chain. The out jack on the effects unit (or last pedal in your chain)
will then connect back to the return jack on the amp.
Adjust each channel’s level control to your liking & set your send level
control as above.
Note: If you hear no sound - your effects loop level control knob is proba-
bly set at zero, or your FX loop is disabled! Refer to the above on/off sec-
tion.
4.3
To Next Page
Loading...
