Revv Owner’s Manual - 9
These dynamic levels can be cycled through both by repeatedly press-
ing the designated momentary toggle switch & by repeatedly pressing
the Channel #2 footswitch.
The amplifier has a midrange focus & to modify this you can either slight-
ly dial back the mid control or switch between the two Contour options
for a bright upper-mid focused sound (on) or a thick lower-mid focused
sound (off).
The Bright switch also controls Channel 2 (independently) & as above
can be set to taste to help you find your desired top end response.
As with Channel One, Channel Two has an independent 40 watt / 7 watt
Output Power Switch. 7w mode will help achieve satisfying sounds at
lower volume and/or give you the option of a tone featuring more power
amp saturation. All else being equal this will result in a more broken up
oldschool sound, compared against letting the preamp take care of
much of the gain in the higher headroom 40w mode.
To Next Page
Loading...
