Revv Owner’s Manual - 38
Control Mode
The foot pedal will always power up in control mode. This mode works
similarly to most other foot pedals - it simply controls the functions of the
amp. Here is how the buttons respond in control mode:
Button One – This button has 2 functions, it switches to channel one
when the amp is not in channel one & switches between foot pedal
modes when held for 2 seconds (control & preset).
Button Two – This button will switch to channel two when the amp is not
in channel two.
Button Three – This button has two functions, it will switch to channel
three when the amp is not in channel three, & cycle through aggression
levels when in channel three.
Button Four – This button has 2 functions, it will switch to channel four
when the amp is not in channel four, & cycle through aggression levels
when in channel four.
Button Five - This buttom toggles FX Loop In/Out. However if the FX loop
is not already active on the faceplate, this will not work, & flash a few times
to signal this.
Button Six - This button has 2 functions. Pressing it toggles between the
2 master volume controls, whereas holding it for 2 seconds activates the
mute ability & the LED will flash.
Note: Bright & Fat functions cannot be changed via the footswitch as
they are considered to be an extension of the EQ. They can be saved to
a bank when in Preset mode however.
7.2
To Next Page
Loading...
