Revv Owner’s Manual - 41
Amp Memory Reset (Factory Default)
If you would like to clear the amp’s memory of all saved program patches
& restore all of the amps settings to the factory default, which includes
MIDI channel (restored to CH1), OMNI Mode, FX Loop (Restored to off at
power up) & a full memory clear, proceed with the procedure below:
With power OFF, press & hold CH3 toggle switch (up) & the CH4 aggres-
sion switch (down) together & turn the power switch to the ON position.
The amplifier will flash the CH3 & CH4 LEDs to confirm that the factory
defaults have been restored.
Specifications
— 4 Channels: Clean, Crunch, Purple Gain, & Red Gain
— Independent output power control on each channel
— Intelligent foot control capabilities
— MIDI capabilities
— CC control of all functions
— OMNI functionality
— 3 band EQ per channel + voicing switches
— REVV tube arrangement: 5 - 12AX7, 1 - 12AT7, 4 - 6L6GC
— Presence & depth control
— Two master volume controls
— 4, 8, 16 ohm output impedance speaker jacks
— Baltic birch head shell
— Dimensions: 26.5” × 10” × 10.5”
— Weight: 45 lbs
8.0
9.0
To Next Page
