Need help?Do you have a question about the REXROTH CS 530 and is the answer not in the manual?
General| Brand | REXROTH |
|---|---|
| Model | CS 530 |
| Category | Controller |
| Language | English |
Configure geographical region and unique truck identification for the controller.
Select between metric and imperial measurement units for system operation.
Define access verification via USB key or password for system setup.
Set the controller's current time in HH:MM:SS format.
Set the controller's current date in MM:DD:YYYY format.
Configure blast timer duration and operational modes for spreading.
Define spinner behavior during pause or stop events.
Select the primary operational mode, such as Standard or Air Gate.
Determine operator permissions for changing settings like gate or material.
Choose liquid application type: PREWET or ANTI-ICING.
Set ground speed threshold for warning alerts.
Configure sensor feedback for liquid level monitoring.
Select the system's dither frequency for operation.
Enable audible feedback and select the system language (English/French).
Reset parameters to factory defaults or clear season totals.
Select and edit valve configurations for conveyor, spinner, or prewet systems.
Understand operational modes for conveyor, spinner, prewet, and deice.
Define conveyor sensor pulses per revolution for closed loop mode.
Manually null minimum and maximum current to valve solenoids.
Perform automatic nulling of valve solenoids using conveyor sensor.
Adjust valve output percentage for smoother conveyor startup.
Configure spinner blast rate as a percentage of maximum output.
Input and edit names for various solid material types.
Set blast rate for closed loop and manual blast percentages.
Configure nine application rate settings for each material type.
Set material discharge weight per conveyor motor revolution.
Enter the gate setting used during material calibration.
Perform automatic material calibration for Auto or Open modes.
Save current configuration settings to the controller's internal memory.
View accumulated trip and season totals for distance and quantity.
Save system parameters to a USB drive using specific file naming conventions.
Load saved parameters from a USB drive into the controller.
Save system logging data to a USB key for computer analysis.
Simulate vehicle ground speed for testing controller functions.
Adjust gate opening for precise material flow control.
Switch to a different solid material type for spreading.
Adjust low and high gate settings specifically for Air Gate mode.
Import log files from USB to computer for analysis.
Filter and select specific logging data by truck, date, and time.
Display selected logging data in a report format.
Erase truck data or regions from the logging system.
To Next Page
