Rextron INTEGRA KVM2 - Installation; Console Connection; Server Connection

Integr a Sun K VM Switch
5
------------------------
------------------------------------------------
------------------------
Installation
InstallationInstallation
Installation
Make sure all servers and the KVM switch modules are powered
down during installation.
Console Connection
To a KVM drawer: Just connect the C-36 connector from a TFT LCD
KVM drawer to the Sun KVM switch module.
To use the Sun KVM module as a standard KVM switch or to connect
a second console to an ISM2208:
Monitor:● A Sun monitor with 13W3 connector can be connected to
the CONSOLE as shown in f igure 3.
● A regular VGA monitor with HDB15 connector may be
connected to the CONSOLE as shown in f igure 4.
Keyboard and mouse: A Sun key board and a mouse should be
connected to the CONSOLE as shown in f igure 3 and 4.
Figure 3: Master console connection
For monitor with 13W3 connector
Integr a Sun K VM Switch
6
Figu
re 4:
Mas
ter
con
sole
con
nect
ion
For
mon
itor
with HDB15 connector
Server Connection
Each Sun serv er is connected to the KVM module with one straight-
through (1-1, 2-2, 3-3…, 8-8) mini-DIN8 cable (as shown in f igure 5)
and one male-to-male HDB15 VGA cable.
Figure 5: Straight-through 1-to-1 mini-DIN8 cable