REYHEE Roamer - Installing the Roamer Controller

Step four: Installing the controller
Follow these instructions if you intend to operate the Roamer with your RIGHT hand.
Identify the installation point (open hole) in front of the right-side armrest.
1)
2)
Ensure the controller installation knob (located beneath the armrest) is partially
loosened. (Turn clockwise to loosen, if needed.)
3)
Install the controller (with the joystick and control buttons facing upward) by sliding
the metal tube into the installation point, all the way to the end.
4)
Secure the controller into the armrest by continuously turning the controller
installation knob counterclockwise until it is fully tightened.
5)
Do NOT yank or pull the controller in such a way that its connection to the
power cable may become damaged, loosened, or otherwise compromised.
Instructions for installing the controller in the right-side armrest:
Assembly (Cont.)
14