Reznor, Photon, Installation Manual, EN 2024-01, D301310 Iss 5 Page No 39 of 52
MS
7. Carefully place the two off replacement
probe gaskets within the replacement probe
kit onto the probe assembly bracket before
refitting on to the unit.
8. Install the replacement probe bracket onto
the side of the combustion chamber using
the 10mm retaining bolts.
9. Check that the replacement gaskets are flat
on the combustion chamber and there are
no signs of damage.
10. Replace the probe assembly access panel
using the 4 off 10mm retaining nuts.
11. Reconnect the spark and flame sensor cables
to the ignition transformer and ignition
controller
12. Replace the access panel on the side of the
unit.
13. Re-instate the gas and electric supplies
having checked that everything is in its’
correct location and all associated screws
and nuts are tight.
All gaskets associated with the
Photon heater have been designed
for SINGLE USE ONLY and MUST
be replaced when carrying out the
steps previously listed.
To Next Page
Loading...
Need help?
General
