• 5: move elevation - pressing and holding the appropriate
button will manually move your mount in elevation (Up
arrow UP, Down arrow DOWN
• 6: move skew - pressing and holding the appropriate button
will manually move your dish in skew (Up arrow right side
DOWN, Down arrow left side DOWN
• 7: test dish - will move the dish in all axis for one complete
cycle
• 8: temperature - will display current operating temperature
of its operating environment.
• 9: test azimuth - will automatically do a test of the azimuth
sensor
• 10: test elevation - will automatically do a test of the
elevation sensor
• 11: test skew - will automatically do a test of the skew sensor
• 12: exit - Selecting this option will take you back to main
menu
NOTE: There is an "OVER TEMPERATURE" condition that will be displayed at
the beginning of the SEARCH function if the operating environment is in excess of
136°F. It will not prevent the SEARCH routine but will warn of potential
damaging heat conditions for the equipment within that operating environment.
Updating and Maintaining Software
The software can be maintained by use of a USB Flash Drive.
• Go to www.rfmogul.com and download the software that best fits your
application. Make sure that it is placed in the "root directory".
• Insert your flash drive into your EAGLE RE-1 controller.
• Turn power ON
• Wait for the load status to be displayed that will indicate that the software
has been successfully loaded (usually 8 seconds).
• Remove the flash drive and press SEARCH to implement acquisition.
To Next Page
Loading...
Need help?
General