Disclaimer
• The RF Mogul EAGLE RE-1 is designed to operate all MotoSAT mounts
with the exception of the round 24" single LNB reflector.
• It will operate the DirecTV, Dish Network, SHAW and Bell TV HD
systems.
• The MotoSAT mount must be mechanically sound with functional motors
and count sensors.
• The antenna must not be bent "tweaked" or damaged in anyway.
• The mount should not have excessive slop or play (wobble) as this will
directly affect the ability of the RF Mogul Eagle controller to peak the
signal for best performance.
• The LNB must be 100% functional. If a Shaw system is being used you
must have a 75E LNB for the 70cm dish and a 60E LNB for the 60cm dish.
We strongly recommend replacement of the current SHAW LNB to the new
xKu version. Changing of the receiver's channel map will have to be done
if you change from a dual LNB to a triple xKu LNB.
• If your focal point on your MotoSAT mount is not within plus or minus 1/4"
to the specifications in this document then correct that issue before trying to
operate the system.
• Check all coax connections and cable for moisture intrusion and wear.
Replace connectors and cable where necessary.
• Mount must not have excessive movement in Azimuth, Elevation or Skew
• Antenna must not be bent or "tweaked".
• The focal point of the LNB on the MotoSAT mount bust be +/- 1/4" to the
specification include in this document.
• When making connections to the 12 pin controller connector make sure they
are clean, properly installed according to the wiring diagram included in this
manual.
• Check that the proper software for your configuration has been loaded into
your controller before pressing SEARCH. If not, load the proper software
and then proceed.
• If your MotoSAT mount cannot perform to its peak capacity due to
hardware issues then EAGLE RE-1 controller will not be able to correct that
issue.
Most installation problems are related to
configuration or connectivity.
To Next Page
Loading...
Need help?
General