pcProx
®
and AIR ID
®
Enroll Readers
User Considerations
The user will first need to perform a
change password-see below.
Change Password
To use the pcProx reader as a password device
the user must first change their password. This
operation is performed differently for each
operating system and application. Please refer
to your User’s Manual for detail.
In general, you will enter your Old Password,
and wave the proximity token to fill in the New
Password and if applicable, the Confirmation
Password fields. If the new password is made
up of the card data + a user supplied PIN, you
will need to add this PIN in both the New
Password and Confirmation Password fields.
If the pcProx reader is configured to append the
ENTER keystroke, you will have difficulty since
the ENTER keystroke will complete the
operation before both fields are filled in. To
avoid this, it will be necessary to re-configure the
device for this Change Password operation.
Once the user performs this operation, the card
may now be used as the password.
Log-on
The operating system loads the USB driver prior
to logon, leaving the device ready to function as
a logon device.
To Next Page
Loading...