Installation
Thermostat
Overview
Thermostat
Setup
Advanced
Installer Menu
Installer’s Guide 7
Equipment
User Menus
Initial Power Up
Turn on AC power to the system. The thermostat will
automatically identify the communicating equipment
installed and configure for the equipment as required.
Messages at Thermostat
As equipment is found on the network, the display will
show, “device” Found. The Searching icon will show until
all equipment is found and configured. If no equipment is
found on the network after approximately five minutes, the
home screen will appear and indicate a Fault.
If the indoor unit is not detected by the network, “Check
System Fault” will be found.
Check system wiring if one of these faults occur.
To Next Page
Loading...
