Rheem II Series - Bath Fill Operation

TM090 12-26 Series II CFGWH Service Instructions
REV AB – Issued February 2019
This document is stored and maintained electronically by Rheem Technical Support. All printed copies are deemed “uncontrolled”
19
BATH FILL OPERATION
Bath Fill switch ON
Operation Flow Chart 4
YES
YES
YES
YES
Bath Fill lamp ON
A B
Bath Fill Operation
Hot water volume
indicator ON
Hot water volume ON
Hot water temp
Indicator ON
NO
YES
Combustion cease
65 Flashing
Bath Fill lamp OFF
Hot water tap closed
Bath Fill lamp OFF
Hot water volume
Indicator OFF
Hot water volume OFF
Hot water temp
Indicator OFF
This section applies only when a
‘ Deluxe Remote Controller’ is installed
NO
Combustion
NO
NO
Bath Fill lamp flashing
Hot water volume
Indicator OFF
Hot water volume OFF
Hot water temp
Indicator OFF
Water flow control
valve closed
Water flow control
valve open
Bath Fill operation
finished
YES
NO
YES
Hot water tap open
Bath fill switch
ON within 6 hrs.
Bath Fill switch
OFF?
Water flow control
valve closed
Set water volume
≤ flow volume
Bath Fill switch
OFF?
NO
B
45 sec later