93
FIGURE 54
FULLY MODULATING – TYPICAL DUAL FUEL APPLICATION – SINGLE STAGE HEAT PUMP (NON-COMMUNICATING)
➤
FIGURE 53
WIRING DIAGRAM FOR MODULATING HEAT (NO DUAL FUEL) (NON-COMMUNICATING)
V / W2
YH (Y2)
Y (Y
2)
Y
L* (Y1)
Y
L (Y1)
*
*
Y Y2
(1) FOR REMOTE SENSOR INSTALLATION
(1) SEE THERMOSTAT INSTALLATION INSTRUCTIONS
THERMOSTAT MODEL: (-)HC-TST401MDMS
REMOTE SENSOR: F1451378
+ S –
12 FT
OUTDOOR SENSOR
(1)
NON-COMMUNICATING
MODULATING THERMOSTAT
*2 STAGE COOLING ONLY
**WARNING: DO NOT APPLY 24VAC TO THE V/W2 TERMINAL ON THE IFC (THIS IS OFTEN DONE DURING SETUP, TROUBLESHOOTING AND/OR
DIAGNOSING PROBLEMS). DOING SO WILL DAMAGE THE THERMOSTAT.
**WARNING: DO NOT APPLY 24VAC TO THE V/W2 TERMINAL ON THE IFC (THIS IS OFTEN DONE DURING SETUP, TROUBLESHOOTING AND/OR
DIAGNOSING PROBLEMS). DOING SO
WILL DAMAGE THE THERMOSTAT.
**
**
To Next Page
Loading...
