RIGHT WALL START
Installation Guide (Continued)
Page
9
R7. FASTEN TEE ASSEMBLY TO TEE WALL BRACKET.
Slide the pre-assembled Tee assembly under Tee Wall
Bracket’s lower lag bolt head. This will temporarily hold
the Assembly in place. Insert 5/16” bolts through
bottom of the Tee Wall Bracket the Tee Assembly and
hand tighten. Check to make sure the Tee Assembly is
perpendicular to wall with a framing square. Tighten
bolts with 1/2” wrench and socket or wrench and nut
driver.
R8. ATTACH TOP OF TEE ASSEMBLY TO WALL.
Place 2' level on the Assembly and push the top
of the diagonal to the wall so that the top wall
bracket rests flat on the wall, aligning holes to
upper vertical Line C. Check level and draw 2”
horizontal level line at the top of the bracket.
INSTALL LEFT END ASSEMBLY:
R9. MARK LOCATION OF LEFT END ASSEMBLY ON WALL. Along Line B, find the first available
stud nearest to 48” from the previously installed assembly. This is your stopping point for the
shelf. Locate the center of stud and mark with a 2” vertical mark (Line C).
R10. ATTACH LEFT WALL BRACKET TO WALL. Place bottom of 2’ level on Line B aligning with
the edge of Line C. With level plumb, mark 2” vertical mark at top of the level. Place the top of
the Left Wall Bracket on horizontal Line B and align the center of the two holes on vertical
Line C. Holding the Left Wall Bracket in position, drill pilot hole in top hole using 3/16” drill bit.
Use a 7/16” socket or nut driver to attach Left Wall Bracket to wall with 3” Lag bolt. Tighten
until snug but movable. Ensure Left Wall Bracket is level. Drill second pilot hole and attach
second 3” lag bolt. Tighten both bolts.
R11.FASTEN LEFT END ASSEMBLY TO LEFT WALL BRACKET. Slide the pre-assembled Left
End Assembly under the Left Wall Bracket's lower lag bolt. This will temporarily hold the
Assembly in place. Insert 5/16” bolt through bottom of the Left Wall Bracket and the Assembly
and hand tighten. Check to make sure the Left End Assembly is perpendicular to the wall with
a framing square. Tighten bolt with 1/2” wrench and socket or wrench and nut driver.
R12. ATTACH DIAGONAL WALL BRACKET TO
WALL. Place 2' level on the assembly and
push the diagonal to the wall so that the top
wall bracket rests flat on the wall, aligning
holes to upper vertical Line C. Check level and
draw 2” horizontal level line at the top of the
bracket. Holding the top bracket in position, drill
the first pilot hole with a 3/16” drill bit. Use
7/16” socket wrench or nut driver to attach the
top bracket to the wall with 3” lag bolt. Make
sure that the top bracket is level and pre-drill
pilot hole and attach second lag bolt. Use a
1/2” wrench and socket or wrench and nut
driver to tighten all the 5/16” bolts and nuts on
the Left End Assembly.
Go to Page 12, “Cut and Install 2x4
Boards” to complete your installation.
If your Kit is an 8' Model, proceed to step R9;
if not, repeat Steps R5 – R8 until all of the pre-assembled Tee Assemblies are installed.
To Next Page
Loading...