RHINO ADVANCED PANIC PACK - Page 11

Commissioning
Once ALL connecons have been made to the Rhino Panic Pack and
power is ready to be applied, you should read this secon before
connuing.
The Rhino Panic Pack leaves the factory programmed with default
setngs and when the system is powered up for the first me the
defaults eingsa re in use.
 Connect the black baery lead to the negave ( –) terminal of
the standby baery and the red baery lead to the posive (+)
terminal of the standby baery. The 7 se gment display will
show PP followed byt he Firmware Version Number e.g. r4 00
 Program the system as described in the next secon
(Programming the Panic Pack).
 Use the diagnoscs page to check zones and outputs (see page
18).
 Test the siren and strobe by pressing panic on a Remote
Controll earnt ont hes ystema nd triggeringa n alarm.
 Replace the lid and secure with the lid screw supplied - do not
over-ghten.
Installaon is now complete and the system is ready for use. Please
ensure the system users are provided with adequate training on
operangt he RhinoP anicP ack .
1111
Replace the lid and secure with the lid screw supplied. Do not over-tighten.
Installation is now complete and the system is ready to use. Please ensure the system users are
provided with adequate training on operating the Rhino Panic Pack.